Description
This American-Built SPX Power Unit with it’s High Capacity 6.3 Gallon Steel Reservoir can be used on most any surface mount lift but is designed for use with some larger 15-18k 2-posters and many 4-post lifts that require a larger reservoir tank than the standard 4 Gallons.
SPX Stone Hydraulics (formerly Fenner Stone) with its’ World Headquarters in Rockford, Illinois is the leading power unit manufacturer in the U.S. market. This American-Built product from Rockford, Illinois will provide years of service and reliability with parts available long after the 12 Month Warranty.
Specifications as follows:
•2 Horsepower Electric Motor (Torques to 3.5 HP)
•208-230 volt, 60 cycle (ready for hard-wire)
•Single Phase
•3450 RPM
•6.3 Gallon Steel Reservoir
•Running amperage at 230v is 18 amps
12 Month Warranty
Please note:
The factory preset relief pressure is fixed at 2320 psi at 1.7 GPM. Your lift may require a higher or even lower pressure setting depending on the make and model of the lift.
Please contact us if you need other specifications BEFORE ordering. If your lift raises too fast or too slow and does not raise to it’s maximum lifting capacity, it does not necessarily mean the power unit is bad as much as it could mean you purchased the wrong power unit. Please remember jacking up the relief valve pressure DOES NOT increase the lifts’ lifting capacity. Never overload the lift past it’s rated capacity.
The 6.3 gallon steel reservoir measures 42″ overall length from the neck to the bottom and is 7″ in diameter.
If you have any doubt whether this power unit will work on your lift please contact us at
(331) 442-9150.
ALL calls are taken by courteous and knowledgeable Owner-Operators